APL 1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed V, V and V. Features. Guaranteed Output Voltage Accuracy within. APLVC-TU 1A Low Dropout Fast Response Positive Regulator Fixed V and V 1A, Details, datasheet, quote on part number: APLVC-TU. APLUC-TU from Anpec Electronics Corp.. Find the PDF Datasheet, Specifications and Distributor Information.

Author: Ket Kajigul
Country: Republic of Macedonia
Language: English (Spanish)
Genre: Automotive
Published (Last): 20 July 2006
Pages: 140
PDF File Size: 6.93 Mb
ePub File Size: 11.38 Mb
ISBN: 708-9-55107-491-8
Downloads: 45537
Price: Free* [*Free Regsitration Required]
Uploader: Voodoogis

Dropout voltage is guar- anteed at a maximum of 1. On-chip thermal limiting provides. For fixed voltage devices R1 and R2 are included in the device. ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and. The data sheet datxsheet fication for load regulation is measured at the output pin of the device. Load regula- tion will be limited by the resistance of the wire con- necting the regulator to the load.

If R1 were con- nected to the load, RP is multiplied by the divider ratio, the effective resistance between the regulator and the load would be: This will improve transient response as well as pro- mote stability.

Current limit is trimmed to ensure specified output current and controlled short-circuit current. The device is available. Dropout voltage is guar.


APL Datasheet(PDF) – Anpec Electronics Coropration

A low-ESR solid tantalum capacitor works extremely well and provides good transient re- sponse and stability over temperature. The APL is a low dropout three-terminal adjustable. Home – IC Supply – Link. Tantalum, or aluminum electrolytic capacitors can be used for bypassing.

The device is available in an adjustable version and fixed output voltages of 1. Load Regulation When the adjustable regulator is used. By plac- ing a resistor between these two terminals, a con- stant Current is caused to flow through R1 and down through R2 to set the overall output voltage. The output available volt- age range of an adjustable version is from 1.

Simplified Application Circuits 1. Basic Adjustable Regulator ues will improve ripple rejection by bypassing the in- put to the regulator. X C should be approximately. This will improve transient response as well as pro.

Normally this current is chosen to be the specified minimum load current of 10mA. On-chip thermal limiting provides protection against any combination of overload that would create excessive junction temperatures.

The APL output capacitor selection is dependent upon the ESR equivalent series resistance of the output capacitor to maintain stability.


Best load regulation is obtained when the top of the resistor divider R1 is tied di- rectly to the output pin of the device, not to the load.

Best load regulation is obtained. For fixed voltage devices the top of R1 is internally.

APL1117 Datasheet

In order to obtain lower dropout voltage and faster transient response, which is critical for low voltage applications, the APL has been optimized. The data sheet speci.

When the adjustable regulator is used. The output available volt.

APL datasheet, APL datasheets, manuals for APL electornic semiconductor part

X C should be approximately equal to R1 at ripple frequency ANPEC reserves the right to datasyeet changes to improve reliability or manufacturability without notice, and advise customers to obtain the latest version of relevant information to verify before placing orders. For fixed voltage devices the top of R1 is internally connected to the output, and the ground pin can be connected to low side of the load. Proper capacitor selection is important to ensure proper operation.