Buy ASTM D R TEST METHOD FOR ASH IN THE ANALYSIS SAMPLE OF COAL AND COKE FROM COAL from SAI Global. ASTM D Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal. standard by ASTM International, 11/01/. Find the most up-to-date version of ASTM D at Engineering
|Published (Last):||22 August 2005|
|PDF File Size:||6.36 Mb|
|ePub File Size:||16.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
See Terminology D for definition of ash. American Journal of Analytical ChemistryVol. Uttam SahaDinku EndaleP.
Rapid and low cost methods of analyzing plant forage quality would be helpful for nutrition aatm of livestock. Test Method D should be used to prepare ash to be used for trace element analysis.
ASTM D3174 – 12
Within MPLS protocol, we compared nine different math treatments on the quality of the calibration models. Ash obtained differs in composition from the inorganic constituents present in the original coal.
We developed and validated calibration models using Near-infrared Reflectance Spectroscopic NIRS analysis for 27 different forage quality parameters of organically grown sunflower and soybean leaves or reproductive parts.
Thus, these models can be reliably applied in the routine analysis of soybean and sunflower forage quality for the purposes of livestock nutrient management decisions. Incineration causes an expulsion of all water, the loss of carbon dioxide from carbonates, the conversion of iron pyrites into ferric oxide, and other chemical reactions.
Ash, as determined by this test method, will differ in amount from ash produced in furnace operations and other firing systems because incineration conditions influence the chemistry and amount of the ash.
Scientific Research An Academic Publisher.
ASTM D – 00 Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal
Development x3174 Validation Calibration Models. References for correcting ash results determined by this test method to a mineral-matter-free basis are listed in Asm DSection 9. It is the responsibility of astmm user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
The results obtained can be applied as the ash in the proximate analysis, Practice Dand in the ultimate analysis, Practice D From a population of samples from both crops, covering multiple sampling dates within the treatments, calibration models were developed utilizing spectral information covering both visible and NIR region of 61 – 85 randomly chosen samples using modified partial least-squares MPLS regression with internal cross validation.
Historical Version s – view previous versions of standard.
ASTM D standard method for ash in the analysis sample of coal and coke – ScienceOpen
For the determination of the constituents in ash, reference is made to Test Methods D f3174, D and D No other units of measurement are included in this standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Link to Active This link will always route to the current Active version of the standard. The results showed that the same model was able to adequately quantify a particular forage quality of both crops managed under different tillage treatments and at different stages of growth.
Glynn TillmanW. Crops were managed under d33174 tillage or no-till with a cover crop of wheat before soybean and rye-crimson clover before sunflower.